8. Depending on the nature swing. If the forklift manufactures korotkoplechevuyu transport long goods (boards, logs, rails, etc.) and on the route of obstacles, allowed the rise of cargo to the desired height and short-term movement of the forklift with a raised load at low speed with a fully tilted back frame truck, after which the goods must be omitted in the transport position and keep moving. 9. Acceleration space is needed to produce smoothly, without jerks, at low engine speeds. During the movement of cargo from the sharp deceleration is not allowed.
Job Fork-lift trucks picked up forklift, equipped forklift pickup, can effectively carry out loading and unloading all kinds of general cargo (boxes, barrels, equipment, timber, etc.) in terms of tonnage, does not exceed its capacity. When the complex work trucks and vehicles, as well as work trucks in storage yards and buildings, ports, airfields and railway stations, the best performance can be developed when stacked on pallets or bars, which give free to strike forks under the load. No special pans or bars reduces the performance of the forklift in connection with the need to invest additional time required for preparatory work on creating gaps for the supply of twisted under load. Consumers are advised to have an exchange fund donov. In order to properly take a load on the fork, follow these steps: 1. Establish the best divorce forks. Drive to Georgia from the most convenient for pick-up cargo on a pitchfork, with the calculation of the center of gravity of the load as close as possible to the front wall and forks, and by the middle of the carriage truck. 2.
Slow movement forklift forks bring forward under a weight until it stops him in front of the fork. 3. Slope frames forklift or lift carriage pull cargo from the ground and set in the transport position. When stowage in stacks recommended to stick to the following rules: 1. Pull up to the stack to raise the load to the desired height stacking. 2. Slow movement of the forklift forward to bring Georgia into the stack size and omitted. Note. In those when the cargo is transported without any special pans, while installing it should be beneath him a bar height of 80-100 mm and a length corresponding to the width of the cargo. When removing the cargo from the stacks must do the following: 1. Pull up to the stack and lift forks to the desired height for the pickup of cargo. 2. Slow movement of the forklift forks fail under load so that the burden rested in front of the fork. 3. Tilt the frame with the load to bounce back. 4. Slowly astern departed from stockyard, halt Counterbalance and omit cargo into transport position. Only thereafter produce transportation cargo direction required.